ItalWax FilmWax wax grains Pour Homme Barber 500g

A medium thickness wax specially designed for beard grooming and full facial hair removal for men.

POUR HOMME BARBER is a medium-thick metallic blue-green wax specially designed for beard modeling and full-face hair removal for men. Based on the highest quality synthetic polymers, it removes thick and coarse facial hair.

This wax easily removes all unwanted hair and allows you to precisely define your beard, eyebrows and sideburns without damaging your skin (and with minimal pain).

Remember to use products before and after waxing.

Packaging: 500 g

Film wax hair removal procedure:
Degrease the skin and remove impurities with a pre-waxing toner. Apply a small amount of film wax in a thin layer, applying it with a spatula, regardless of the direction of hair growth. Leave a small “donkey’s eye” at the end, which will later serve as a handle for removing the wax.

TIP: Take your time and apply the wax gently so that it adheres well to the skin.

The wax will harden within 6-10 seconds. In this short time, it should catch all the hairs (without sticking to your fingers). Stretch the skin in the opposite direction of epilation (this will help remove the wax faster). Repeat the procedure on other areas of the skin. After epilation, use oil-free post-epilation products.

Common mistakes when working with film wax:
The wax stretches like caramel and is difficult to remove
→ The wax has not had time to harden.
✅ Apply a small amount of wax to the area again, wait 2-3 seconds and remove.
Hairs remain after epilation
→ The wax was applied superficially, without sufficient pressure from the spatula on the skin, so the hairs did not reach the wax layer.
✅ Apply wax to the areas where the hairs remain and repeat epilation.
Wax does not harden
→ The applied layer is too thick.
✅ This wax is applied in a very thin layer - carefully spread it over the selected area and use a much thinner layer.
After removing the wax, edges remain on the skin
→ Uneven application of wax.
✅ Wax must be applied evenly - the edges and the middle of the layer must be the same thickness.